Crown Trade – Gloss – White – 1L & 2.5L.
Crown Trade Gloss is solvent based, so clean brushes with White Spirit.
The paint has a high quality decorative and protective finish for use over correctly prepared joinery and metal.
Dries to a high gloss finish and is made for interior and exterior use.
The gloss has an exceptionally hard wearing and flexible finish, with excellent opacity and film build.
The paint also has good colour retention.
Drying Time:
In good conditions, touch dry after 6 hours and recoatable after 16 – 24 hours.
Always ensure that the previous coat is fully dry before another application.
A characteristic of the new technology used in this product is that whiteness intensifies as the paint dries.
Coverage:
12-15m² per litre depending on the surface texture.
Weather conditions:
Don’t apply when the air or substrate temperatures are likely to fall below 8ºC or when the relative humidity is above 80% during application or the drying period, and don’t over apply.
Preparation:
All new metals:
Lightly abrade to a bright (not polished) surface – excluding galvanised surfaces.
Wash with hot water and Sugar Soap to remove oil, grease or any other contaminants, and change the water frequently.
Rinse thoroughly with clean water, allowing the surface to dry, then prime it.
New Wood Surfaces :
All surfaces must be sound, clean, suitably dry and free from anything that will interfere with the adhesion of the materials to be applied.
Rub down with a suitable grade of abrasive paper and round sharp edges to a 1-3mm radius, then remove all dust.
Timber with oils/extractives must be swabbed with clean methylated spirits, frequently changing the face of the cloth.
Treat any knots with two coats of fresh knotting and fill any fixing holes, open joints and shallow surface defects with a filler.
Apply a primer and undercoat.
Previously Decorated Wood:
All surfaces must be sound, clean, suitably dry and free from anything that will interfere with the adhesion of the materials to be applied.
Remove all loose, failing or suspect paint, and remove grey and denatured surfaces by rubbing down with abrasive paper and feather edges of sound paint.
Also, remove all dust, and any defective putty glazing.
Clean and prime rebates, and replacement putties must be allowed to form a hard skin.
Treat knots with two thin coats of fresh knotting and fill any fixing holes, cracks and shallow surface defects with a filler.
Wash remaining sound paint with hot water and a liquid detergent solution to remove any contaminants, frequently changing the water.
Wet abrade to provide a key, rinse with clean water to remove all residues and allow to dry.
APPLICATION:
Stir well before and during use.
Apply using good quality tools – a synthetic or bristle brush or a short/medium pile roller and maintain a wet edge.
CLEANING:
Return surplus material to container.
Wash tools and equipment with White Spirit immediately after use.
STORAGE:
Store upright and secure.
Store in secure dry conditions inaccessible to children or animals.
Containers should be kept closed during storage.
Do not store below 5ºC or above 40ºC.
We are available via WhatsApp – click here:
